Installing Lights-Out Management Features; Configuring The Disk Drives - HP ML310 - ProLiant - G2 User Manual

To select the Input Languages window, click Add.
6.
At the Add Input Language window, select the Keyboard Layout/IME, and then correct the Input
7.
Language.
Click OK.
8.
From the list, select the correct Default input language.
9.
To exit the Text Services and Input Languages window, click OK.
10.
To exit the Regional and Language Options window, click OK.
11.

Installing Lights-Out management features

If you purchased a RILOE board for the server or purchased a server with an iLO controller installed, use
the following procedure to complete the installation. Do not attempt to install the device driver until after
installing the operating system.
IMPORTANT:
Controller and the iLO controller as a Base System Device. The Hardware Wizard continues to
appear until the driver installation has been completed.
At the Found New Hardware Wizard window, click Locate and install driver software.
1.
Select Search for a Suitable Driver for My Device.
2.
Click Next.
3.
Select Specify a Location, and then clear the Floppy Drive and CD-ROM options.
4.
Click Next.
5.
Enter the following path in the textbox:
6.
C:\Drivers
Click OK.
7.
At the Driver Files Search Results screen, click Next, and then click Finish.
8.

Configuring the disk drives

The primary logical drive, which contains the operating system, is the only drive on the server that is
configured during the operating system installation. Additional space that is not partitioned is also located
on the primary drive. This nonpartitioned space and any additional disk drives on the server must be
partitioned and formatted using Disk Administrator before they can be available for use.
If an array controller has been purchased with the server, see "Configuring array controllers (on page
21)" for procedures.
Click Start, and then select All Programs>Administrative Tools>Computer Management.
1.
Expand the Storage directory, and then select Disk Management. The disk and logical drive
2.
information appears on the right side of the window.
If the new logical drive created by the ACU does not appear on the bottom right side of the
3.
Computer Management window as unallocated space, click Action, and then click Rescan Disks.
On the bottom right panel, right-click Disk 1 and then select Initialize Disk.
4.
On the Initialize Disk screen, select Disk 1, and then click OK. The disk is identified as a Basic disk.
5.
The Microsoft® Hardware Wizard detects the RILOE board as a PCI Memory
Post-installation tasks 14