Ipv6 Neighbor Settings - D-Link DGS-3200-16 - Switch - Stackable User Manual

xStack

IPv6 Neighbor Settings

The user can configure the Switch's IPv6 neighbor settings. The Switch's current IPv6 neighbor settings will be displayed in the
table at the bottom of this window.
To view the following window, click Configuration > IPv6 Neighbor Settings:
Enter the Interface Name, Neighbor IPv6 Address, and the Link Layer MAC Address and then click the Add button. The State
can be set to All, Address, Static, or Dynamic.
To look for an IPv6 Neighbor Settings table entry, enter the Interface Name, select the desired State in the middle section of this
window, and then click the Find button.
To delete all the entries being displayed on the table at the bottom of this window, click the Clear button.
The following parameters may be configured or viewed:
Parameter Description
Enter the name of the IPv6 neighbor. To search for all the current interfaces on the Switch, go to
Interface Name
the second Interface Name field in the middle part of the window, tick the All check box, and then
click the Find button.
Neighbor IPv6 Enter the neighbor IPv6 address.
Address
Link Layer MAC Enter the link layer MAC address.
Address
State Use the drop-down menu to select All, Address, Static, or Dynamic.
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 2- 8. IPv6 Neighbor Settings window
10