D-Link DGS-3200-16 - Switch - Stackable User Manual page 175

xStack
To set the Access Rule for Packet Content, adjust the following parameters and click Apply.
Parameter Description
Access ID (1-
Type in a unique identifier number for this access. This value can be set from 1 to 200.
200)
Auto Assign – Ticking this check box will instruct the Switch to automatically assign an Access ID
for the rule being created.
Action Select Permit to specify that the packets that match the access profile are forwarded by the Switch,
according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port defined in
the config mirror port command. Port Mirroring must be enabled and a target port must be set.
Priority (0-7) Tick the corresponding check box if you want to re-write the 802.1p default priority of a packet to
the value entered in the Priority field, which meets the criteria specified previously in this command,
before forwarding it on to the specified CoS queue. Otherwise, a packet will have its incoming
802.1p user priority re-written to its original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
Replace Tick this check box to replace the Priority value in the adjacent field.
Priority
Replace DSCP Select this option to instruct the Switch to replace the DSCP value (in a packet that meets the
(0-63) selected criteria) with the value entered in the adjacent field. When an ACL rule is added to
change both the priority and DSCP of an IPv4 packet, only one of them can be modified due
to a chip limitation. Currently the priority is changed when both the priority and DSCP are
set to be modified.
Chunk This field will instruct the Switch to mask the packet header beginning with the offset value
specified.
Rx Rate (1- Use this to limit Rx bandwidth for the profile being configured. This rate is implemented using the
following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10 then the ingress
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6 - 20. Add Access Rule window for Packet Content
162