Ssh Authmode And Algorithm Settings - D-Link DGS-3200-16 - Switch - Stackable User Manual

xStack
To configure the SSH server on the Switch, modify the following parameters and click Apply:
Parameter
SSH Server Status
Max Session (1-8)
Connection Timeout
(120-600 sec)
Max. Auth. Fail Time
(2-20)
Session Rekeying

SSH Authmode and Algorithm Settings

Users can configure the desired types of SSH algorithms used for authentication encryption. There are three categories of
algorithms listed and specific algorithms of each may be enabled or disabled by ticking their corresponding check boxes. All
algorithms are enabled by default.
To view the following window, click Security > SSH > SSH Authmode and Algorithm Settings:
The following algorithms may be set:
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 5 - 31. SSH Configuration window
Description
Use the radio buttons to enable or disable SSH on the Switch. The default is Disabled.
Enter a value between 1 and 8 to set the number of users that may simultaneously access
the Switch. The default setting is 8.
Allows the user to set the connection timeout. The user may set a time between 120 and 600
seconds. The default setting is 120 seconds.
Allows the Administrator to set the maximum number of attempts that a user may try to log
on to the SSH Server utilizing the SSH authentication. After the maximum number of
attempts has been exceeded, the Switch will be disconnected and the user must reconnect
to the Switch to attempt another login. The number of maximum attempts may be set
between 2 and 20. The default setting is 2.
This field is used to set the time period that the Switch will change the security shell
encryptions by using the pull-down menu. The available options are Never, 10 min, 30 min,
and 60 min. The default setting is Never.
Figure 5 - 32. SSH Authmode and Algorithm Settings window
121