D-Link DES-3624i User Manual page 82

To add an entry or make a change to an entry on the Static Multicast Forwarding Table, enter a VLAN ID number,
enter a MAC address, choose Egress or Forbidden for each port, choose a State (Delete on Reset, Delete on Timeout,
Invalid, or Permanent), and then press APPLY to put the change into effect.
Items in the above screen are defined as follows:
VID This is the VLAN that will be defined on this screen. Note a VLAN ID number is from 1 to 4094.
MAC Address The MAC address of the newly created Static Multicast Forwarding Table entry.
Egress/Forbidden Position the cursor over the dash "–" representing the appropriate port number and press the
<space bar> to select E for Egress, F for Forbidden, or leave the dash "–". An E designates the specified port as a static
member of the VLAN. A dash means the port is not given VLAN membership for the VID entered above. An F forbids
the port from joining a VLAN dynamically.
State Choose how you want the Switch to deal with the newly created Static Multicast Forwarding table entry:
Delete on Reset, Delete on Timeout, Invalid, or Permanent.
Choose Browse Static Multicast Forwarding Table from the bottom of the Static Multicast Forwarding
Table Configuration screen above to access the following:
82
Figure 6-44. Static Multicast Forwarding Table Configuration screen
Stackable NWay Ethernet Switch User's Guide
Using the Console Interface