Configure Igmp - D-Link DES-3624i User Manual

Stackable NWay Ethernet Switch User's Guide
Figure 6-23. Static Multicast Filtering Table Configuration screen
To add an entry or make a change to an entry on the Static Multicast Filtering Table Configuation screen, select
Add or Remove in the first field, enter the multicast MAC address in the next field, enter the VLAN ID number, assign
the outgoing ports by typing a V, and then press APPLY to put the changes into effect.

Configure IGMP

Internet Group Management Protocol (IGMP) allows multicasting on your network. When IP Multicast Filtering is
enabled, the Switch can intelligently forward (rather that broadcast) IGMP queries and reports sent between devices
connected to the Switch and an IGMP-enabled device hosting IGMP on your network.
Basically, in these submenus you define whether the Switch can intelligently forward IGMP packets, and you must also
define which 802.1Q VLANs (if present) can send and receive IGMP and Multicast packets.
To access the IGMP Configuration screen, select Configure IGMP from the System Configuration menu. The
following screen appears:
64 Using the Console Interface