Packing And Shipping The Switch 5500G-Ei - 3Com 3CR17251-91 - Switch 5500G-EI Stackable Gigabit Ethernet Getting Started Manual

Packing and
Shipping the Switch
5500G-EI
This section describes how to correctly package your Switch 5500G-EI
should you need to return the Switch to 3Com.
WARNING: If returning the unit to 3Com for repair, ensure that you fit
the rear blanking plates for the PSU and module. If the unit is received by
3Com without the blanking plates in place your warranty could be
invalidated.
WARNING: The unit should be packaged safely to ensure that you do
not invalidate the repair.
Use the following sequence of steps to ensure that you package your unit
correctly:
1 Orientate your Switch so that the PSU blanking plate is on the left
(looking down at the top of the unit) as shown in
2 Secure one of the polystyrene supports to side of the unit with the PSU
blanking plate, ensuring that the wider recess on the support is fitted
round the blanking plate. Secure the remaining support to the opposite
side of the unit in the same way.
3 Place the unit in the box with the PSU blanking plate side placed next to
the cable packaging.
Figure 16 Correct Orientation When Packing the Switch 5500G-EI
PSU Blanking Plate
Cable Packaging
PSU
SIDE

Packing and Shipping the Switch 5500G-EI

Polystyrene Supports
Switch Unit
47
Figure 16.
PORT
SIDE