Guidelines For Interconnecting Units; Unit Numbering Within The Fabric - 3Com 3CR17251-91 - Switch 5500G-EI Stackable Gigabit Ethernet Getting Started Manual

74 C 4: C
HAPTER REATING AN
Guidelines For
Interconnecting
Units
Unit Numbering
within the Fabric
XRN S F
TACKING ABRIC
This section offers some guidelines for creating a Fabric. Using these
guidelines will help prevent problems arising when setting up your Fabric.
The maximum number of Switch units that can be interconnected is
■
eight.
It is not possible to create a Fabric by interconnecting a 3Com Switch
■
5500 with any other 3Com device (such as a 5500G-EI) or mix
Enhanced Image (EI) Switch 5500 units with Standard Image (SI) units.
3Com strongly recommends that you upgrade all Switches to be
■
interconnected to the latest software agent.
3Com recommends that you remove the configuration file from a
■
Switch unit that has previously been used elsewhere in your network
before you interconnect to an existing unit. If you do not do this,
problems may be caused by conflicting Switch configurations. Use the
dir command from the User View to display the configuration files
stored on the Switch and locate the [filename].cfg file. Do NOT
under any circumstances remove the 3comoscfg.def file (this is the
default configuration file).
For a detailed description of how XRN Technology operates and
implementation guidelines, please refer to the Configuration Guide on
the CD-ROM that accompanies your Switch.
When a Fabric is created using the Switch 5500 the unit numbering can
be determined in two ways.
You can manually assign unit IDs 1 to 8 to specific units using the
■
change[self-unit, unit-id] to [1-8,
auto-numbering] command from the System View. If you
manually assign unit IDs to a Switch via the change command the IDs
will be retained after a power cycle.
If you add a unit to a Fabric that has previously been manually
configured with a unit ID and this conflicts with an ID already within
the Fabric, then the Switch with the lowest MAC address assumes the
ID in question and the other unit will automatically renumber.
3Com recommends that you manually assign the unit IDs within the
Fabric if you wish to have predictability of knowing which units have
which IDs at all times.
Fabric topology is 'discovered' and the units auto-number their IDs.
■