Replacing The Bluetooth Module - Packard Bell ENTJ75 Service Manual

Replacing the Bluetooth module

www.packardbell.com
Tools you need to complete this task:
Phillips #0 screwdriver
Flat screwdriver
Screws removed during this task:
•
1 black M2×5 (hard drive)
•
1 black M2.5×6 (optical drive)
•
3 black M2.5×6 (keyboard cover)
•
2 black M2.5×6 (LCD panel hinge - bottom)
•
2 black M2.5×6+Nylok (LCD panel hinge - top)
•
•
3 M2.5×6 black (palm rest - top side)
To replace the Bluetooth module:
1
Complete the steps in
2
Complete the steps in
3
Complete the steps in
4
If the notebook has a wireless card installed, unplug the antenna cables.
5
Remove the hard drive screw, and then remove the hard drive from its
compartment.
or Non-marring plastic scribe
10 M2.5×6 black (palm rest - base side)
"Preparing the notebook" on page
"Removing the battery" on page
"Removing the bay cover" on page
47.
48.
49.
83