Packard Bell ENTJ75 Service Manual page 41

www.packardbell.com
Removing a password
To remove a password:
1
↑ ↓
Press or to highlight the
field, then press
The Set Supervisor Password or Set User Password box opens.
2
Type the current password, then press
3
Enter
Press twice without entering anything in the new and confirm password
fields.
You will be prompted to confirm the password removal.
4
Enter
Press .
5
F10
Press to save the password and close the Setup Utility or you can
proceed to setting a user password.
Resetting a password
If you have forgotten the user password, the computer will continue to function
normally but you will have limited access to the Setup utility.
If you have enabled the Password on Boot field and you forget the supervisor
password, you will not be able to boot up the computer. The same thing applies
if you forget the HDD password.
To clear a lost BIOS password (user or supervisor password) you need to short
the clear password hardware gap located on the system board. Go to
for instructions.
To regain access to your computer if you lose the HDD password, you need to
generate a master password and unlock your hard drive. Go to
instructions.
Set Supervisor Password
Enter
.
Set User Password
or
Enter
.
page 41
page 40
for
35