Table of Contents
Advertisement
Error Messages List
Error Messages
Allocation Error for: device
Failing Bits: nnnn
Fixed Disk n
Invalid System
Configuration Data
I/O device IRQ conflict
Operating system not found
No-Beep Symptoms
Symptom / Error
No beep, power-on
indicator turns off and LCD
is blank.
No beep, power-on
indicator turns on and LCD
is blank.
92
Action in Sequence
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
DIMM
BIOS ROM
System board
None
BIOS ROM
System board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
Enter Setup and see if fixed disk and drive A: are
properly identified.
Diskette drive
Hard disk drive
System board
Action in Sequence
Power source (battery pack and power adapter).
See "Power System Check" on page 88.
Ensure every connector is connected tightly and
correctly.
Reconnect the DIMM.
LED board.
System board.
Power source (battery pack and power adapter).
See "Power System Check" on page 88.
Reconnect the LCD connector
Hard disk drive
LCD inverter ID
LCD cable
LCD Inverter
LCD
System board
Troubleshooting
Advertisement
Table of Contents
