Table of Contents
Advertisement
4091-001
Mid Frame Assembly Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the sheet feeder.
4. Remove the system board.
5. Remove the small feed roll assemblies.
6. Remove the small feed roll bracket assembly.
7. Remove the printhead carrier assembly.
8. Lift up the rear of the mid frame assembly and remove it from
the carrier frame.
Paper Feed Motor Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Disconnect the paper feed motor from the system board.
4. Remove the two screws mounting the paper feed motor to the
drive train assembly and remove the motor.
5. See the Note in the
Printhead Carrier Assembly Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the sheet feeder.
4. Unlock the four printhead cable connectors and disconnect the
printhead cable from the system board.
5. Unlatch the cable retainer from the carrier frame.
6. Remove the retainer spring from the left end of the carrier guide
rod.
7. Remove the screw from the right end of the carrier guide rod.
8. Slide the carrier guide rod out the left side of the machine.
9. Remove the belt from the back of the carrier.
10. Lift the carrier out of the machine.
4-8
"" on page
2-10.
Advertisement
Table of Contents
