Table of Contents
Advertisement
4091-001
Large Feed Roll Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the sheet feeder.
4. Remove the base assembly.
5. Remove the system board.
6. Remove the printhead carrier assembly.
7. Remove the small feed roll assemblies.
8. Remove the small feed roll bracket assembly.
9. Remove the mid frame assembly.
10. Remove the maintenance station assembly.
11. Turn and remove the retainer at the right end of the large feed
roller.
12. Remove the large feed roller from the carrier frame.
Maintenance Station Assembly Removal
1. Remove the front cover.
2. Remove the rear cover.
3. Remove the base assembly.
4. Depress the clip on the left and right side of the carrier frame
that secures the maintenance station assembly and slide the
assembly out of the machine.
Maintenance Wiper and Cap Removal
1. Remove the front cover.
2. Push the carrier to the left away from the maintenance station.
3. Gently pull the cap and wiper off their mountings.
Repair Information 4-7
Advertisement
Table of Contents
