Lexmark 2030 Color Jetprinter Service Manual page 20

4091-001
FRU / Function
1 Print Cartridge
2 Color Print
Cartridge Cross
Contamination
3 Printhead Carrier
Assembly
4 System Board
Printhead Cable
Rubber Backer
2-10
Action
Be sure the machine contains good print
cartridges.
Cross contamination of color inks results in
incorrect colors printed, as when green prints for
yellow, (when yellow and blue are mixed in the
print cartridge). This problem resolves quickly as
the print cartridge is used.
If cross contamination occurs, check the following:
• The maintenance station wiper for damage.
• The printhead nozzle plate was resealed with
tape.
Reseat the printhead cables in the system board
and check the following parts for wear or damage:
• Print Cartridge Latch
• Latch Spring
• Carrier
• Run the "Test Page" on page
break in the diagonal line of the test pattern. A
broken line indicates one or more print nozzles
are not working. Run the test again to verify the
failure. If there are even breaks in the diagonal
line similar to the pattern shown below, ensure
the printhead cables are connected properly. If
the symptom remains, replace the system
board.
If there is a single break or random breaks in the
diagonal line, check the following:
• Check the gold-plated contacts, on the end of
the cable that connect to the carrier, for dirt and
wear. Use only a clean dry cloth to clean the
contacts. Also check the cable for damage. You
may need to remove the cable from the carrier
to inspect it.
• A worn rubber backer results in poor contact
between the printhead cable and the print
cartridge. Check the rubber backer for wear.
3-1. Look for a