Dell 6224 - PowerConnect Switch - Stackable Getting Started Manual page 38

1
The system is not configured for SNMP management by default. To
manage the switch using SNMP (required for Dell Open Manage Network
Manager) you can:
o Set up the initial SNMP version 1 & 2 now.
o Return later and set up other SNMP accounts. (For more information
on setting up an SNMP version 3 account, see the user
documentation).
SNMP
Would you like to configure the SNMP management interface now?
To configure the SNMP management account you must specify the
management system IP address and the "community string" or
password that the particular management system uses to access the
switch. The wizard automatically assigns the highest access level
[Privilege Level 15] to this account. You can use Dell Open Manage
Network Manager or other management interfaces to change this
setting and to add additional management systems later. For more
information on adding management systems, see the User's Guide.
SNMP
15]
To add a management station:
Please enter the SNMP community string to be used
{Dell_Network_Manager}:
{Dell_Network_Manager}
Dell_Network_Manager<Enter>
注：
仅激活 SNMPv1/2c
引擎 ID
Please enter the IP address of the Management System (A.B.C.D)
or wildcard (0.0.0.0) to manage from any Management Station
{0.0.0.0}:
192.168.1.10<Enter>
36
[Dell Open Manage Network Manager
SNMP 1
3
SNMP
Dell Open Manage Network Manager
禁
看等
{0.0.0.0}
2
SNMP
[Y/N]
IP
SNMP
SNMP
SNMPv3 直 返回而
IP [A.B.C.D]
SNMP
]
y <Enter>
[
高权限
SNMPv3 全
[0.0.0.0]
SNMP
)