Display Test Function; Light Control For X-10 Devices; Change Languages - GE NX-148E - Security NetworX LCD Keypad User Manual

DISPLAY TEST FUNCTION

This function will perform a test of the LCD display. No alarms or reports will be
sent.
Step 1 Press r
pixels and LED indicators will flash until another key is pressed.
Step 2 Press any key to end the test.
LIGHT CONTROL FOR X-10 DEVICES (Optional, if programmed)
This menu allows you to control up to ten X-10 devices from each keypad.
Step 1 Press r
Number 0 - 9".
Step 2 Enter the number of the X-10 device you want to control. The LCD screen
will show the light number on the left. On the right side of the display it will
prompt you to turn the light (X-10 device) "On" or "Off".
Step 3 Press the • to turn the X-10 device "On" or press the –
X-10 device "Off".
Step 4 The LCD screen will again prompt you to "Select Light Number 0 - 9".
Step 5 Repeat Steps 2 and 3 until complete.
Step 6 Press #

CHANGE LANGUAGES

This function allows you to switch between the two languages programmed in your
keypad. NOTE: You must exit any other function mode before attempting to
change languages.
Step 1 Press
language.
Step 2 Repeat Step 1 to revert to the first language.
14
4 5 . The test will be performed and all of the display
4 6 . The LCD screen will prompt you to "Select Light
to exit from the X-10 menu.
r
4 9 . The LCD keypad is now toggled to the second
to turn the
NX-148E-CF