Appendix A - Event Log - GE NX-148E - Security NetworX LCD Keypad User Manual

NOTE: Your system may not have all of the features listed in this table.
DISPLAY
TXlobat
ZN Lost
Duress
Man Fire
Aux 2
Panic
KP Tamper
BoxTamp
AC Fail
OverCur
Srn Tamp
Tel Flt
Exp Trb
Log Full
Open
Close
Exit Err
Rec Close
Autotest
Start Prog
End Prog
Start Dnld
End Dnld
NX148E-CF

APPENDIX A - EVENT LOG

Transmitter
Low Battery
Zone Lost
Duress
Manual Fire
Auxiliary 2
Panic
Keypad
Tamper
Box Tamper
AC Fail
Over Current
Siren Tamper
Telephone
Fault
Expansion
Trouble
Log Full
Open
Close
Exit Error
Recent Close
Auto Test
Start
Programming
End
Programming
Start Download Download session is started.
End Download Download session is ended.
DESCRIPTION
The transmitter has a low battery.
A wireless or multiplexed zone device is not
reporting to the control.
The control has been armed or disarmed with a
Duress code.
Keypad "Fire" has been activated.
Keypad "Medical" has been activated.
Keypad "Panic" has been activated.
The keypad tamper has been activated.
The box tamper circuit has been activated.
AC failure has been detected.
A short circuit of a power supply has occurred.
A siren or speaker tamper has been detected.
A telephone fault or tamper has been detected.
An expansion device or keypad is not reporting
to the control.
The event log is full. Old events will be pushed
out as new ones enter the log.
Reports user number, date, time and partition of
opening.
Reports user number, date, time and partition of
closing.
Entry/Exit zone was faulted at the instant the
exit delay expired.
An alarm occurred within 5 minutes after the
control was armed.
Sending a communicator test at a specified
interval.
Local programming is started.
Local programming is ended.
25