Group Bypass; Unbypassing; Emergency Activation Keys - GE NX-148E - Security NetworX LCD Keypad User Manual

Procedure #2
Press r
Step 1
Use the • – scroll keys to browse through the custom descriptions
Step 2
for the zones in this system.
Step 3 To bypass or unbypass a specific zone, press the [BYPASS] key while
that zone is displayed.
Step 4 When finished, press the #

GROUP BYPASS

By pressing the [BYPASS] key, followed by the 0 key, then the [BYPASS] key
again, all zones that are designated as group bypass zones will be bypassed.
Press the [BYPASS] key again to exit group bypassing.

UNBYPASSING

To manually unbypass zones, perform the bypassing procedure on a zone that is
already bypassed. NOTE: All zones will automatically be unbypassed each time
the system is disarmed.

EMERGENCY ACTIVATION KEYS

NOTE: You must press and hold these keys for 2 seconds to activate these
functions. Your system may not be programmed for these activations.
Fire Key - If programmed, you can activate the Fire alarm by pressing the
Emergency Activation [Fire] key for two seconds. If your system is connected to a
monitoring center, an emergency report could be sent to that center. This key
should only be pressed in an emergency situation requiring response by fire
department personnel.
NX148E-CF
If you do not know the number of the zone you wish to bypass,
use the following steps:
•
The description for zone 1 will be displayed.
key to return to the code entry screen.
11