Advertisement
Programming a
Personal Passcode
For security reasons, it is very important that you program your own personal
Passcode into the digital lock. The factory Passcode
immediately.
Programming Your Personal Passcode
1.
Using the factory assigned Passcode
(See page 2).
2.
Locate and then press and release the small red memory
button located inside the safe on the edge of the lock
cover. The keypad will beep twice and the yellow LED will
light.
3.
Select a Passcode using 3 to 8 numbers (no letters) and
enter it on the keypad.
4.
After entering the numbers, press the B key. The keypad
will again beep twice and the yellow LED will light. This
will complete the programming of your personal Passcode.
Leave the door open and proceed to Testing Your New
Passcode.
Testing Your New Passcode
1.
With the door in the open position, push the lock handle
into the closed position. In about 3 seconds, the safe will
automatically lock.
2.
Enter your new personal Passcode onto the keypad followed
by the letter A and the digital lock should click open.
Example:
Important:
Your new Passcode will always consist of your selected number code followed by the
letter A.
3.
Pull the handle and open the safe.
4.
If the new Passcode does not unlock the safe, then repeat
the steps to program your personal Passcode and retest.
Once programming is completed, write your personal Passcode
down and store it in a safe and secure place away from the safe. The
factory pre-set Passcode will no longer open your safe.
6
159A
should be changed
(159A)
, open the safe.
Memory
Button
Yellow
Light
A
Hide quick links:
Advertisement
