Table of Contents
Advertisement
Programming a Personal Passcode
Programming a Personal Passcode
For security reasons, it is very important that you program
your own personal Passcode into the digital lock. The factory
Passcode 159 should be changed immediately.
To program your own unique 3-8 digit Passcode, follow these
steps:
1.
Open the protective cover on the front of the safe to expose
the keypad.
2.
With the safe in the open position, press in on the small
reset button located on the inside top edge of the door.
NOTE: After pressing the reset button, the red and green
lights on the keypad will flash to indicate the programming
is authorized and you have 10 seconds to begin.
3.
Enter your new 3-8 digit Passcode followed by the # Key.
Immediately repeat the sequence, beginning with the new
Passcode followed by the # Key.
4.
The green light will light up solid, indicating your new
Passcode has been successfully entered.
5.
Your new Passcode will now be comprised of the 3-8 digit
sequence you selected, always followed by the # sign. The
factory pre-set Passcode will no longer open the safe.
6.
You may change your Passcode at any time by repeating
the same steps.
7.
It is important that you write down your personal Passcode
and secure it in a safe location away from the safe.
NOTE: If you forget your personal Passcode, access to the
safe can be made using the Emergency Override Key.
(See page 6)
Home and Office Security Safes
PASSCODE
RESET BUTTON
GREEN
LIGHT
5
Hide quick links:
Advertisement
Table of Contents
