Advertisement
Opening Safe For The First Time
Opening Your Safe for the First Time Using
the Pre-set Factory Code.
Batteries have been pre- installed at the factory. Using the
factory pre-set Passcode 159A, open the safe as follows:
1.
Enter the three digit number 159 on the keypad followed
by the letter A. If entered correctly, the green LED will light
and the lock will click.
2.
Pull the handle open within 5 seconds and open
the door.
Important:
If no action is taken, the safe will automatically relock in 5 seconds and the code
will need to be re-entered.
3.
A red LED indicates that the Passcode was entered
incorrectly. Re-enter the code and try again.
Security Lockout:
The safe is designed to lock out the keypad if the wrong Passcode is entered
multiple times.
•
After the 3rd error:
•
4-6 errors:
•
7+ errors:
If you have forgotten the Passcode, entry can be made using the Emergency
Override Key.
Closing Your Safe
1.
Make sure nothing inside the safe is obstructing the door from completely
closing.
2.
Close the safe door and press the handle into the locked position.
Important:
This safe is equipped with an interior light. The control switch is located on the
inside door panel. When closing the safe it is important that the light switch be
turned to the off position. Failure to do so will drain the batteries of power and
the safe will not open when the digital key pad is used.
2
20 second lock-out. (waiting period)
5 minute lock-out.
1 hour lock-out.
(See page 7).
Red
Yellow
Green
Light
Light
Light
Red
Light
Hide quick links:
Advertisement
