Measurement With Set Pressure; Measurement With Desired Systolic Pressure - A&D UA-1020 Instruction Manual

MEASUREMENT WITH SET PRESSURE

The UA-1020 is designed to detect the pulse and to inflate the cuff to a systolic
pressure level automatically. If re-inflation occurs repeatedly, use the following
methods.
During the blood pressure measurement, re-inflation may occur. A fixed pressure
value can be set to avoid re-inflation.
1. At step 6 of the clock adjustment procedure (see page
E-10), press the
mode. The current setting blinks.
2. Press the
about 30 mmHg or more above your expected systolic
pressure from the following.
: Automatic pressurization (default value)
AUTO
: Pressure value of 180 mmHg (fixed)
180
: Pressure value of 210 mmHg (fixed)
210
: Pressure value of 240 mmHg (fixed)
240
3. Press the
SET
Press the
START
non-operation, the device will turn off automatically. The next measurement
will be performed with the new pressure value.

MEASUREMENT WITH DESIRED SYSTOLIC PRESSURE

Use this method when re-inflation occurs repeatedly even if the pressure value is
set to in the procedure above or when the results are not displayed even if
240
the pressure decreases to 20 mmHg or less.
1. Place the cuff on the arm (preferably the left arm).
2. Press and hold the
about 30 to 40 mmHg higher than your expected
systolic pressure appears.
3. When the desired number is reached, release the
button to start measurement. Continue to
START
measure your blood pressure as described on the
previous page.
E-15
button to go to the pressure setting
SET
or button to select a pressure value
button to go to the TriCheck setting mode.
button to turn the device off. After three minutes of
button until a number
START
Press and hold the button
Release the button
Press and hold the button
A&D Medical (Toll-Free): 1-888-726-9966
or
or
TriCheck
Turn off
setting mode
TriCheck
Turn off
setting mode
At heart level
At heart level
at the desired
systolic pressure
Release the button
Refer to previous page
at the desired
systolic pressure for measurement
Refer to previous page
for measurement
START
START