Setting The Processor Speed - HP LC2000r - NetServer - 128 MB RAM Upgrade Manual

Chapter 1
3. If installing more processor modules, install a new VRM for each new
processor module, by repeating Steps 1–2.

Setting the Processor Speed

If you are installing processors with a faster (or slower) speed setting than
installed previously, you must change the switch settings of the configuration
switch located on the system board. All processors in the system must operated at
the same speed.
1. Determine the processor speed setting from Table 1-1.
Table 1-1. Processor Module Speed Settings
Processor
Speeds
550 MHz
600 MHz
650 MHz
700 MHz
750 MHz
HP NetServer LH 6000/6000r Processor Upgrade
3
2 6
5
4
1
Figure 1-8. Inserting the VRM
SW 1 SW 2 SW 3
ON OFF OFF
OFF ON
OFF ON
OFF ON OFF
OFF ON OFF
VRM
Locations
SW 4
OFF
ON ON
ON OFF
ON
OFF
11