Final Installation - Viking FDB451 Installation Instructions Manual

Final Installation

9a
1
x4
x2
3
For installation with trim, secure dishwasher by
attaching provided mounting plugs and wood screws
through trim panels into cabinets. Attach screws
through top brackets into cabinets.
10
Minimum
20"
(50.8 cm)
from floor
Install High Loop Clip, which is provided, a minimum of
20" (50.8 cm) from the floor. Refer to the Drain section
of "General Information" for proper installation
requirements.
12a
(Discharge with food waste disposer)
Note: Be sure to remove the knockout or plug from the
fitting of the disposer before connecting drain line.
20
9b
x2
For installation without trim, secure dishwasher by
attaching screws through top brackets into cabinets.
11
1.0"
(2.5 cm)
Cut here for
5/8" (1.6 cm)
Cut here for
3/4" (1.9 cm)
Identify discharge connection size; cut line to correct
size and connect. Clamp if necessary.
12b
(Standard discharge)
Final Installation
(cont.)
12c Air Gap
(Discharge with air gap)
13
Connect water line.
21
12d Air Gap
(Discharge with food waste disposer and air gap)
14
Plug LED light into dishwasher (select models only)
and install kick plate.
Note: DO NOT block the dry air exhausts (rectangular
slots on the access panel) with kick plate or base board.
Blocking the opening could reduce the dry performance
and cause unwanted condensation.