Viking FDB451 Installation Instructions Manual page 10

Installation
1
2
2
4
x4
3
Carefully lay dishwasher on its back and attach the kick
plate brackets. Screws for the brackets will already be
in the base. Note: Be careful not to pinch hoses or
power cord beneath dishwasher.
3
Using tie strap attached to dishwasher, band water line,
drain line, and power cord together.
4b
1
1
2
x2
For installation without trim (301 models only), attach
brackets with two screws (1 per bracket).
18
2
2
To adjust the depth of the kick plate, loosen screws on
the bracket and position in the required depth. Tighten
screws and repeat for other side.
4a
1
1
2
x2
For installation with trim, attach brackets with two
screws (1 per bracket).
5
Position unit in front of cutout.
Installation
(cont.)
6
Slide unit into opening; be sure to feed water, electrical
and discharge lines into adjacent cabinet.
Leveling
7
Equal distance
D O D O DOW
W N W N N
UP
U P U P
DOWN UP
Place a level on handle, then adjust to appropriate
height. Left and right adjust side to side and center
adjusts front to back.
19
8
To check level, front to back, pull the top rack half-way out of
unit. The rack should remain stationary and not move in or out.
Note: Leveling is important for optimal performance.