Hardwire Conduit Option
(301 Models, cont.)
Green
7
(Ground)
3
Connect ground wire. Tighten screws on strain relief.
Note: Reinstall front plate.
Hardwire Conduit Option
(451 Models)
1
Remove any loose items in the dishwasher and carefully
Remove bottom pan. Note: Rapid removal of the bottom pan will
lay the dishwasher on its back. Note: Be careful not to
cause damage to the moisture sensor. For installation and servicing,
pinch hoses or power cord beneath dishwasher.
slowly pull the bottom pan from the unit and disconnect the wire from
3
3
1
x2
2
Remove front plate.
14
8
2
3
x4
1
Run wire through grommet on bottom pan.
Replace bottom pan.
2
3
2
x4
the moisture sensor, which is located in the center of the pan.
4
3
1
2
Remove terminal block cover. Remove factory installed
power cable from terminal block.
Hardwire Conduit Option
(451 Models, cont.)
5
1
2
Attach UL approved 3/4" strain relief (not included) to
bottom of terminal box. Run wires through strain relief.
7
2
Green
1
(Ground)
3
Connect ground wire. Tighten screws on strain relief.
Note: Reinstall terminal block cover and front plate.
15
6
White
1
(Neutral)
1
2
Black
(Line)
Connect wires to terminal block.
8
2
3
x4
1
Run wire through grommet on bottom pan.
Replace bottom pan.