Memory - HP j6700 - Workstation Service Handbook

Memory

There is a label on the inside cover of the workstation which shows the J6700's memory
loading sequence.
J6700 Memory Configuration
The J6700 workstation has sixteen memory slots, labeled 0A, 0B to 7A, 7B. Memory
DIMMs must be installed in pairs in this workstation, and both DIMMs in each pair must
be of equal size. The DIMMs for this workstation currently come in 512 MB and 1 GB
sizes. This workstation comes with two 512 MB DIMMs as its standard configuration from
the factory. Thus, currently the minimum memory configuration for this workstation is
1GB, and the maximum is 16 GB.
DIMMs should be loaded in the order shown with 0A, 0B being the first pair of DIMMs
loaded, and 7A, 7B being the last pair loaded. Figure 2-1 shows the installation sequence.
NOTE If memory is installed improperly or it is bad and fastboot is not enabled, your
workstation's operating system will not boot-up and a DIMM error will
appear in your workstation's LCD. For more information see the section
"Displaying and Setting Fastboot Mode" in Chapter 5.
Figure 2-1. Memory Loading Sequence in the J6700
Chapter 2
Field Replaceable Unit (FRU) Configurations
Configuration
33