Furuno GP-80 Operator's Manual page 61

Loading waypoint/route
1) Do steps 1 through 9 in "Loading light-
house/buoy data."
2) Press t or s to select WPT/RTE.
3) Press to select Command. Stop, on the
same line as Command, appears in reverse
video.
4) Press sto select Start. The message shown
in Figure 8-16 appears.
Loading erases current data
and stops Route navigation
Are you sure to load?
ENT: Yes MENU: No
Figure 8-16
5) Press the [NU/CU ENT] key. The mes-
sage shown in Figure 8-17 appears.
Now loading
Waypoint/Route data !
MENU:Stop
Figure 8-17
6) Operate the computer to output data.
When data is loaded, the cursor shifts to
Stop.
7) Press the [MENU ESC] key. When data
is loaded successfully, The message in
Figure 8-18 appears.
Loading ended successfully
Press any key
Figure 8-18
If data could not be loaded, the message
shown in Figure 8-19 appears.
Failed in loading
Invalid data
Press any key
Figure 8-19
Loading waypoint data from
YEOMAN equipment
1) Do steps 1 through 9 in "Loading light-
house data."
2) Press t or s to select WPT.
3) Press to select Command.
4) Press s to select Start. The message shown
in Figure 8-20 appears.
Are you sure to load ?
ENT: Yes MENU:No
Figure 8-20
5) Press the [NU/CU ENT] key. The mes-
sage shown in Figure 8-21 appears.
Now loading
Waypoint data !
MENU:Stop
Figure 8-21
6) Operate the YEOMAN to output data.
When data is loaded, the cursor automati-
cally shifts to "Stop". Waypoints are
loaded into empty areas. When the
waypoint area becomes full, the message
shown in Figure 8-22 appears.
Waypoint area is full !
Can't load any data
Press any key to stop
Figure 8-22
8 – 9