6. CHECKING THE SEWING PATTERN
When checking by operating only the feed mechanism
1. Turn on the power switch.
(The POWER indicator will illuminate and the program number will flash in the display window.)
2. Press the TEST switch.
(The TEST indicator will illuminate.)
3. Depress the foot switch to the second step.
Only the feed mechanism will move.
[Check that the needle hole q does not protrude past the frame of the work clamp w.]
* If you depress the foot switch again and keep it depresses after the feed mechanism has started to
move, the feeding speed will increase.
* If you would like to stop the feed while it is moving, press the TEST switch.
4. Press the TEST switch.
(The TEST indicator will switch off and the test mode will be cleared.)
5. Depress the foot switch.
The work clamp will rise and the preparation for sewing will be completed.
To ensure safety during use ......
You can prevent accidental changes being made to
programs by setting DIP switches 7 and 8 to ON.
When DIP switch 7 is ON
... The sewing pattern cannot be enlarged.
When DIP switch 8 is ON
... The program number cannot be changed.
LK3-B430E-, B431E-, B432E-, B433E- Mark II
6. CHECKING THE SEWING PATTERN
1st step
2nd step
q
T E S T
w
T E S T
22