Installing The Machine Head; Installing The Head Rest; Installing The Liquid Cooling Tank, Optional - Brother LK3-B432E MKII Instruction Manual

3-8 . Installing the machine head

1. Insert the head hinges q into the machine head so that they are parallel, and then secure them with the
two set screws w.
2. Place the machine head gently on top of the rubber cushions e and cushions r.
NOTE:
Pull the cords t out as shown in the illustration above in order to prevent them from being clamped by the machine
head.
3. Install the hinge presser y with the two screws u.

3-9 . Installing the head rest

q

3-10 .Installing the liquid cooling tank, optional

w
q
r
t
w
q
LK3-B430E-, B431E-, B432E-, B433E- Mark II
u
e
Tap the head rest q into the table hole.
NOTE:
Tap the head rest securely into the table hole.
1. Remove the rubber plug, and then push the liquid
cooling tank q.
2. Tighten it with the set screw w.
3. INSTALLATION
y
17
66
13
12