Installing The Motor Cover; Installing The Spool Stand; Installing The Eye Guard - Brother LK3-B432E MKII Instruction Manual

3. INSTALLATION

3-17 . Installing the motor cover

t
1. Install the motor cover q to the motor back cover
w with the screws e and the flat washers r.
2. Pass the motor shaft through the notch in the mo-
tor back cover w, and then tighten the screws y
and the washers u so that the clearance between
the motor pulley t and the motor cover q is
uniform.

3-19 . Installing the eye guard

Attach all safety devices before using the sewing machine.
If the machine is used without these devices attached, injury may result.
LK3-B430E Mark II
LK3-B432E Mark II
q
LK3-B433E Mark II
e
[LK3-B431E Mark II]
q
e
17
q
w
r
e
u
y
CAUTION
w
w
LK3-B430E-, B431E-, B432E-, B433E- Mark II

3-18 . Installing the spool stand

Assemble the spool stand q while referring to the
spool stand instruction manual, and then install the
spool stand q at the right side of the work table.
Install the eye guard assy w to the face plate q with
the two screws e.
q