Error Messages - Sony STR-DH540 Operating Instructions Manual

"BRAVIA" Sync (Control
for HDMI)
The Control for HDMI function does not
work.
• Check the HDMI connection
(page 22).
• Make sure "Control for HDMI" is set
to "On" in HDMI Settings menu.
• Make sure the connected equipment is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings
on the connected equipment. Refer to
the operating instructions of the
connected equipment.
• If you unplug the HDMI cable or
change the connection, repeat the
procedures of "Preparing for the
"BRAVIA" Sync" (page 47).
• When "Control for HDMI" is set to
"Off", the "BRAVIA" Sync does not
work properly, even if the equipment
is connected to the HDMI IN jack.
• The types and the number of
equipment which can be controlled by
the "BRAVIA" Sync are restricted in
the HDMI CEC standard as follows.
– Recording equipment (Blu-ray Disc
recorder, DVD recorder, etc.): up to
3 equipment
– Playback equipment (Blu-ray Disc
player, DVD player, etc.): up to 3
equipment
– Tuner-related equipment: up to 4
equipment (The receiver uses one of
them for its OSD operations.)
– AV receiver (audio system): up to 1
equipment
Remote control
The remote control does not function.
• Point the remote control at the remote
control sensor on the receiver
(page 10).
• Remove any obstacles in the path
between the remote control and the
receiver.
• Replace all the batteries in the remote
control with new ones, if they are
weak.
• Make sure you select the correct input
on the remote control.

Error messages

If there is a malfunction, a message appears
on the display panel. You can check the
condition of the system by the message. If
any problem persists, consult your nearest
Sony dealer.
PROTECTOR
Irregular current is output to the
speakers, or the receiver is covered and
ventilation holes are blocked. The
receiver will automatically turn off after
a few seconds. Remove the object
covering the upper panel of the receiver,
check the speaker connection and turn
on the power again.
USB FAIL
An over current from the
was detected. The receiver will
automatically turn off after a few
seconds. Check the iPod/iPhone or USB
device, then unplug it and turn on the
power again.
For other messages, see "Message list after
Auto Calibration measurement" (page 56),
"iPod/iPhone message list" (page 35) and
"USB message list" (page 38).
(USB) port
75
GB