Sony STR-DH540 Operating Instructions Manual page 40

Tuning to a station
directly (Direct Tuning)
You can enter the frequency of a station
directly by using the numeric buttons.
1
Press D.TUNING.
2
Press the numeric buttons to enter
the frequency, then press
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 (b 0*)
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
* Press 0 for Europe and Australia models
only.
Tip
Adjust the direction of the AM loop antenna
(aerial) for optimum reception upon tuning
to an AM station.
If you cannot tune to a
station
"– – – .– – MHz" or "– – – – kHz" appears
and then the screen returns to the current
frequency.
Make sure you have entered the right
frequency. If not, repeat steps 1 to 3. If you
still cannot tune to a station, the frequency
may not be in use in your area.
40
GB
Changing the AM tuning
scale
(USA and Canada models only)
You can change the AM tuning scale to
either 9 kHz or 10 kHz using the buttons on
the receiver.
?/1
.
TUNING MODE
1
Press ?/1 to turn off the receiver.
2
While holding down TUNING
MODE, press ?/1 on the receiver.
The current AM tuning scale is
changed to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
Notes
• Depending on the settings, the receiver may take
some time to change the AM tuning scale.
• All preset stations will be erased when you
change the tuning scale.