Audio Settings Menu - Sony STR-DH540 Operating Instructions Manual

x Crossover Freq. (Speaker
crossover frequency)
Lets you set the bass crossover frequency
of speakers that the speaker size has been
set to "Small" in the Speaker Settings
menu. Measured speaker crossover
frequency is set for each speaker after the
Auto Calibration.
1
Select the parameter under the
speaker which you want to adjust the
crossover frequency, then press
2
Adjust the value, then press
x Test Tone
Lets you select the test tone type on the
"Test Tone" screen.
Tips
• To adjust the level of all speakers at the same
2
time, press +/–. You can also use MASTER
VOLUME on the receiver.
• The adjusted value is shown on the TV screen
during adjustment.
To output test tone from each
speaker
You can output test tone from the speakers
in sequence.
1
Select "Test Tone", then press
2
Select "Test Tone" again, then press
.
3
Adjust the parameter, then press
• Off
• Auto: The test tone is output from each
speaker in sequence.
4
Select the speaker which you want to
adjust the speaker level, then press
.
5
Adjust the level of the selected
speaker, then press
x Distance Unit
Lets you select the unit of measurement for
setting distances.
• feet: The distance is displayed in feet.
• meter: The distance is displayed in
meters.
58
GB

Audio Settings menu

You can adjust settings for the audio to suit
your preference.
x Night Mode
Lets you retain a theater-like environment
at low volume levels. For details, see
"Using the Night Mode function"
.
(page 45).
.
x Equalizer
Lets you adjust the bass and treble level for
front speakers. For details, see "Adjusting
the equalizer" (page 45).
x Sound Field
Lets you select a sound effect applied to
input signals. For details, see "Enjoying
Sound Effects" (page 42).
You can set the function for each input
independently.
x A/V Sync. (Synchronizes
Lets you delay the output of audio to
.
minimize the time gap between audio
output and visual display.
• On (Delay time: 60 ms): The audio
.
• Off (Delay time: 0 ms): The audio output
• This function is useful when you use a large
.
• This function does not work when "Analog
• The delay time may vary depending on audio
audio with video output)
output is delayed so that the time gap
between the audio output and visual
display is minimized.
is not delayed.
Notes
LCD or plasma monitor or a projector.
Direct" is being used.
format, sound field, speaker pattern and speaker
distance settings.