Brother Innov-ís 2800D User Manual page 82

SEWING THE STITCHES
Buttonholes are sewn from the front of the presser foot to the back, as shown below.
a Reinforcement stitching
a
Select a stitch, and then attach presser foot
"A".
b
Mark the position and length of the
buttonhole on the fabric.
Memo
The maximum buttonhole length is 28 mm (approx. 1-
1/6 inches) (diameter + thickness of the button).
c
Pull out the button holder plate on the presser
foot, and then insert the button that will be
put through the buttonhole.
* The size of the buttonhole is set by positioning the
button in the button holder plate.
Note
Pass the thread under the presser foot.
a
a Button holder plate
80
a
a
a
d
Hold the outside frame of the buttonhole foot
toward the back with your finger, and then
lower the presser foot so that the mark on the
fabric aligns with the marks on the buttonhole
foot.
a
A
b
a Mark on fabric
b Marks on presser foot
Note
• Slide the outside frame of the buttonhole foot
backward as far as possible, making sure that there
is no gap behind the part of the foot marked "A", as
shown in the illustration. If the buttonhole foot is not
slid back as far as possible, the buttonhole will not
be sewn at the correct size.
• Pass the thread under the presser foot.
a