Step 9: Replace Cover 1 And Front Bezel; Step 10: Install Hard Disk Drive Modules; Hot-Swap Disk Drive Configurations - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 2

Step 9: Replace Cover 1 and Front Bezel

NOTE If you removed the air baffle indicated in Figure 2-4 or 2-5,
replace it now, before you replace Cover 1.
1. Replace Cover 1 as described in your HP NetServer installation guide.
2. If the HP NetServer is mounted in a rack, slide the HP NetServer into the
rack, and secure the HP NetServer to the rack, as described in the
installation guide or rack documentation.
3. Install the front bezel as described in the installation guide or rack
documentation. Lock the front bezel.
4. After the HP NetServer is secured in a rack with an anti-tip foot, you can
retract the anti-tip foot if desired.

Step 10: Install Hard Disk Drive Modules

Hot-Swap Disk Drive Configurations

NOTE If a duplex board is installed in the secondary mass storage
cage, refer to the HP NetServer Duplex Kit Installation Guide
or your HP NetServer installation guide for drive
configurations and SCSI addresses (IDs).
20
Installation