Step 4: Install Mass Storage Cage - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 2
2. Remove Cover 1 as described in your HP NetServer installation guide.
3. The HP NetServer has a cover plate on its chassis front over the expansion
bay in which you will install the mass storage cage. Unscrew its six
retaining screws, as shown in Figure 2-1, and remove the cover plate.
Store the cover plate and screws for future use, in case you ever remove the
second mass storage cage.

Step 4: Install Mass Storage Cage

NOTE The secondary mass storage cage is shipped with filler panels
installed. Leave the filler panels in place while you install the
cage. Do not install hard disk drives before you install the cage.
If you are installing a hot-swap mass storage cage that already
contains hard disk drives, remove them before you install the
cage.
Figure 2-1. Remove Cover Plate
Installation
9