Installing The Usb Driver - Canon PowerShot A20 Software Starter Manual

Installing the USB Driver

(Preinstalled Windows 98/Me/2000 Systems Only)
Notes Regarding Installation
• Ensure that you install the contents of the Canon Digital Camera Solution Disk
before you attach the camera to the computer's USB port. This will allow the
automatic selection of the correct USB driver.
• The USB driver only needs to be installed the first time the camera is connected via the
USB interface. Installation is not required from the second time onward.
• Do not cancel the installation partway through. Allow the procedure to finish completely
before exiting. The camera may not operate correctly if the installation is incomplete.
• Read the "Troubleshooting the USB Driver Installation" section on page 52 if the
installation cancels itself during the procedure, if the installation does not proceed as
described in these procedures, or if you think that the drivers are not properly installed.
• Read the "Uninstalling the USB Driver" section on page 52 for instructions for that
procedure.
Installing the USB Driver
Windows 2000 users should log on as the Administrator before commencing installation.
1. Once you have attached the USB cable to the camera and computer, set
the camera to the mode for communicating with a computer.
Refer to Where to Find Instructions for Attaching Your Camera to a
Computer (
The "Add New Hardware Wizard" dialog will appear after a moment and
automatically install the USB driver.
p. ii) for connection instructions.
9