HP StorageWorks 2/8-EL - SAN Switch Installation Manual page 59

7. Log onto the switch (with administrative privileges). The default
8. Record the IP address on the label affixed to the SAN Switch 2/8 front panel.
SAN Switch 2/8 Version 3.1.x Installation Guide
To configure port settings in a UNIX
tip /dev/ttyb -9600
administrative logon is admin and the default password is password.
a. Enter the following at the prompt:
ipAddrSet
b. Enter the following information at the corresponding prompts:
— Ethernet IP Address [10.77.77.77]:
Enter the new Ethernet IP address.
— Ethernet subnetmask [0.0.0.0]:
Enter the new Ethernet subnetmask.
— Fibre Channel IP Address [none]:
Enter the new Fibre Channel IP address if desired.
— Fibre Channel subnetmask [none]:
Enter the new Fibre Channel subnetmask if desired.
— Gateway Address [172.17.1.1]:
Enter the new gateway address.
— Set IP address now? [y = set now, n = next
reboot]:
Enter y to set now.
c. To verify that the IP address was entered correctly, type:
ipAddrShow
d. Once the IP address is verified as correct, remove the Serial cable, and
replace the shipping plug in the Serial port.
Caution: The Serial port is intended only for use during the initial setting of
the IP address and for service purposes. Using the Serial port during normal
switch operation or for regular maintenance is not recommended.
Installing the SAN Switch 2/8
®
environment, type:
59