Enabling Licensed Features; Running Basic Switch Operations Using Telnet; Logging In To The Switch - HP StorageWorks 2/16 - SAN Switch Installation Manual

Enabling Licensed Features

Licensed features such as QuickLoop and Fabric Watch are already loaded onto
the switch firmware, but must be enabled with a license key. Once you have
purchased these features you are provided with a key to unlock the feature.
Use these steps to enable a licensed feature.
1. Log in to the switch as the admin user.
2. At the command line, enter the following command:
Note:
sensitive.

Running Basic Switch Operations Using Telnet

Read the following sections to run common switch operations.

Logging in to the Switch

Follow this procedure to log in to the switch.
1. Open a Telnet connection to the switch. The login prompt displays if the
Note:
enable connection through telnet.
2. At the login prompt, enter the user ID you are logging in as. For example:
SAN Switch 2/16 Version 3.1.2 Installation Guide
licenseAdd aaaBbbCcc
(where aaaBbbCcc is the license key for a particular feature.)
You must enter a license key for each feature to activate. License keys are case
Telnet connection successfully finds the switch in the network.
The switch must be connected to your IP network through the RS-232 port to
login: admin
The password prompt is displayed if the user exists.
Managing the SAN Switch 2/16
61