10I/N, 10E, 10Ex, 12I And 12I/N Printers; Preparing Your Printer - Oki OKICOLOR8n Hardware Installation Manual

Installing Flash
Overview
Memory in the
OKIPAGE
10e, 10ex, 12i and
12i/n Printers
For models listed above, the flash memory SIMM is installed
on one of the following optional accessory boards.
· 1 MB Memory Expansion Kit (Part # 70033101)
· RS-232C Serial Interface Kit (Part # 00025302)
®
· OKILAN 310e Network Interface Kit (OKIPAGE 10i only)
(Part # 70032901)
®
· OKILAN 310e+ Network Interface Kit (OKIPAGE 12i
only) (Part # 70032902)
10i, 10i/n,
®
If your printer is not equipped with one of these accessories,
you will need to purchase the accessory to install the Flash
SIMM in the printer. Expansion sockets are provided on each
board included in the option kits.

Preparing Your Printer

!
CAUTION! SIMMs and circuit boards can be damaged
by static electricity and rough handling. Keep the
SIMM card and option board in the packaging until
you're ready to perform the installation. To avoid
damage to the SIMM card, ground yourself by touching
the chassis of your computer each time before handling.
!
WARNING! Disconnect printer from power before
beginning installation procedure.
1 Turn the printer off and unplug the power cord.
2 Detach the interface cable.
3 If an option board is already installed in your printer, turn
the screws counterclockwise, then slide the board out of
the printer.
Hardware Installation Guide: English
|
5