Asus P7H55-M LE User Manual page 24

9. IDE connector (40-1 pin PRI_EIDE) (for P7H55-M LE only)
The onboard IDE connector is for Ultra DMA 100/66 signal cable. There are three
connectors on each Ultra DMA 100/66 signal cable: blue, black, and gray. Connect the
blue connector to the motherboard's IDE connector, then select one of the following
modes to configure your devices:
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
cable connector. This prevents incorrect insertion when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the
same setting.
P7H55-M LE IDE connector
1-15
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
PRI_EIDE
PIN1
NOTE:Orient the red markings
on the IDE ribbon cable to PIN 1.
Mode of device(s) Cable connector
-
Master
Slave
Master
Slave
Chapter 1: Product introduction
Black
Black
Gray
Black or gray