Storage Setup - Oki MPS711c User Manual

Storage Setup

Note:
This menu only displays if the optional SD card is
installed.
ITEM
Check File
System
Check All
Sectors
Enable SD
Card
Erase SD
Card
62
SETTINGS
Execute Resolves mismatch between actual memory
and displayed memory available in a file
system. Performs administration data (FAT
information) recovery. Performs recovery only
for an SD Card.
Execute Performs recovery of defective SD Card sector
information and a file system mismatch
mentioned above.
No Even if a machine is inoperable at installation
because of a faulty SD Card, the machine can
Yes
be made operable by setting this parameter to
No (ignores the existence of the SD Card).
When No is set, access to a SD Card results in
FAIL because the SD Card is regarded as not
attached.
After setting change and exit from the menu,
the printer will restart.
Execute Deletion of all data stored in the SD Card.
DoD 5220.22-M sanitizing formula is used for
clearing the card. The machine will restart
after changing setup. The following message
appears after pressing the Enter button.
Are You Sure? Yes / No
No = return to the source menu.
Yes = the procedure for clearing disk stars
immediately after the machine reboots.
If the Cancel button is held down during
erasing, the following confirmation messages
will appear to discontinue processing.
Do You Wish to Cancel? Yes / No
No= procedure will continue.
Yes = procedure will discontinue.
– MPS610c/MPS711c User's Guide
EXPLANATION