Wyse R10L Installation Manual page 20

16
Chapter 4
6. (Optional) Leave the default-selected Preserve data partition check box
(recommended in most cases) unless you do not want to preserve any existing custom
data partition you have on the thin client (outside of the partition used by the firmware).
7. Select all three contents options (OS Image, BIOS, and CMOS).
8. Click Next to open the browse dialog box.
Figure 15 Browse for image file
9. Click Browse.
Figure 16 Browse to select commandsXml.xml
10.Navigate to the RX0L_LE 2G_4G WES2009 Conversion Image folder on your hard
drive (this is the location you selected in "Step 1: Copy the RX0L_LE 2G_4G WES2009
Conversion Image Folder to Your Local Hard Drive"), click on the commandsXml.xml
file to select it (you may need to select the All Files option from the Files of Type box to
display the commandsXml.xml file for selection), and then click Open.
11. In the browse dialog box, click Next to open the Prepare the USB Drive dialog box.
Tip
This option is only available for use with thin clients using multiple data
partitions totalling 4 GB or larger, allowing you to remove the partition used
for custom data that is not write filter protected (this is the custom data
partition outside of the partition used for write filter protected firmware).
Caution
Do not use the commandsXml.xml file directly from the Conversion
Software Assembly DVD-ROM.