Installing Rx0L Flash And Ram; Requirements - Wyse R10L Installation Manual

2

Installing Rx0L Flash and RAM

This chapter contains information for users of Wyse Rx0L thin clients who must install new
flash and/or RAM. If you are installing firmware only, you can skip this chapter and
proceed to"Installing WES2009 Firmware."
IMPORTANT:
•
•

Requirements

•
•
•
For Rx0L users who do not need to install new flash, you can skip "Step 2: Install the
Rx0L Flash Module."
For Rx0L users who do not need to install new RAM, you can skip "Step 3: Install the
Rx0L RAM Module."
Small Phillips screwdriver
Needle-nose pliers
(Optional) Container for holding screws
Warning
Flash and RAM modules may be susceptible to damage by Electro-Static
Discharge (ESD). All industry-standard cautions should be followed to avoid
ESD. Before you remove or install a module, touch any metal part of the
chassis and keep that contact with the chassis during the installation
process.