What's Next - Wyse C90LEW Installation Manual

4
Chapter 2
4. Lift the top cover to remove it and expose the main board as shown in Figure 2. Notice
5. Note where the connector of the flash module is located in Figure 2. Remove the
Figure 2 Removing the existing flash module
6. Install the new flash module in the reverse order of removing the original flash module.
7. Replace the top cover in the reverse order of removing it as described in steps 4 and 3.
8. Attach any support feet.
9. Reconnect the video display, keyboard, mouse, and power adapter to the cloud client

What's Next

Continue with "Installing Firmware."
that the rear of the cloud client is positioned at the bottom of the photo.
Warning
Flash modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.
existing flash module. Use needle-nose pliers to squeeze the plastic standoff lock as
you rock the flash module back and forth to remove it from the socket.
Carefully press the flash module onto the standoff lock and connector, making sure to
lock it into place.
before connecting to an electrical outlet.
Caution
Do not turn on the cloud client. The cloud client is ready to re-image,
however the flash module does not contain an operating system. Turning on
power to your cloud client without firmware will display the error message
"NO OPERATING SYSTEM FOUND."