Connecting An Antenna Or Cable Tv (No Box); Connecting A Dvd Or Blu-Ray Player - Insignia NS-19LD120A13 User Manual

Connecting an antenna or cable TV (no box)

To connect an antenna or cable TV (no box):
1 Make sure that your TV/DVD combo's power
cord is unplugged, and all connected
equipment is turned off.
2 Connect a coaxial cable to the ANT/CABLE IN
jack on the side of your TV/DVD combo and to
the antenna or cable TV wall jack.
3 Plug your TV/DVD combo's power cord into a
power outlet, then turn on your TV/DVD combo.
4 Go through the Setup Wizard on page 19.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
• If the signal level for a channel is weak, the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact
your cable or satellite TV provider about
upgrading to a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV/DVD combo is still
displayed as SD, thus the picture quality will not
be as clear or crisp as it would be if the content
was originally recorded in HD.
12
Antenna or
cable TV (no box)
Side of TV
www.insigniaproducts.com
NS-19LD120A13 Insignia 19" LCD TV/DVD Combo

Connecting a DVD or Blu-ray player

Using HDMI (best)
To connect a DVD or Blu-ray player using HDMI:
1 Make sure that your TV/DVD combo's power
cord is unplugged and the DVD or Blu-ray player
is turned off.
2 Connect an HDMI cable (not provided) to the
HDMI jack on the side of your TV/DVD combo
and to the HDMI OUT jack on the DVD or
Blu-ray player.
3 Plug your TV/DVD combo's power cord into a
power outlet, then turn on your TV/DVD combo.
4 Turn on the DVD or Blu-ray player, then set it to
the correct output mode. For more information,
see the documentation that came with the
player.
5 Press INPUT to open the Input Source list.
6 Press INPUT repeatedly or press
highlight HDMI, then press ENTER
DVD or Blu-ray player
Side of TV
or to
.
/