Connect An Antenna Or Cable Tv (No Box) - Insignia NS-32DD310NA15 User Manual

Connect an antenna or cable TV (no box)

On your TV
Coaxial cable
connector
ANT/CABLE
jack
1 Make sure that your TV's AC power adapter is unplugged and all connected equipment is turned off.
2 Connect a coaxial cable (not provided) to the ANT/CABLE jack on the back of your TV and to the antenna or
cable TV wall jack.
3 Plug your TV's AC power adapter into a power outlet, then turn on your TV.
4 Press INPUT to open the INPUT SOURCE list.
5 Press or to highlight TV, then press ENTER.
6 If you cannot tune to channels you know exist, scan for channels. See
page 54.
Notes
• Use a coaxial cable to eliminate interference and noise from radio
• Do not bundle the coaxial cable with the AC power adapter or other
• If the antenna is not installed correctly, contact qualified service
• If the signal level for a channel is weak, the picture may be distorted.
• If the picture quality is good on some channels and poor on others, the
• If you connect to cable TV without a set-top box and experience poor
• Many high-definition (HD) channels upscale standard-definition (SD)
18
waves.
cables.
personnel to correct the problem.
Adjust the antenna or use a highly directional outdoor or set-top
antenna with a built-in amplifier.
problem may be caused by a poor or weak signal from the broadcaster
or cable TV provider.
picture quality, you may need to install a set-top box to improve signal
reception and picture quality. Contact your cable TV provider about
upgrading to a set-top box.
content. The picture displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as it would be if the
content was originally recorded in HD.
www.insigniaproducts.com
NS-32DD310NA15 Insignia 32" LED TV/DVD Combo
Antenna or cable TV
(no box)
Back of TV
"Automatically scan for
Coaxial cable
channels" on