6. If the drive you installed is a removable-media drive, remove the bay panel
7. Connect the power and signal cables to the drive.
Installing a security U-bolt
To help prevent hardware theft, you can add a security U-bolt and cable to your
computer. After you add the security cable, make sure that it does not interfere
with other cables that are connected to the computer.
To install a U-bolt:
1. Remove the cover (see "Removing the cover" on page 21).
2. Use a tool, such as a screwdriver, to remove the two metal knockouts.
3. Insert the U-bolt through the rear panel; then attach and tighten the nuts with
you installed the drive and gently pry the static shield loose from the drive bay.
from the front bezel and place the bezel frame that comes with your computer
over the drive bay.
What to do next
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Replacing the cover and connecting the
cables" on page 32.
an appropriately sized or adjustable wrench.
Chapter 3. Installing internal options — desktop model
31