Installing Memory; Supported Memory Configurations - HP Z210 Series User Manual

7

Installing memory

This section describes how to add memory to your workstation.

Supported memory configurations

Refer to the quick specs at
information for HP workstations.
NOTE:
— Install only HP-approved, unbuffered DDR3 DIMMs.
— HP Z210 CMT and SFF Workstations support Error Checking and Correcting (ECC) and non-ECC
DIMM memory modules.
— Do not intermix ECC and non-ECC memory. The system will not boot and will produce a memory
error.
— For maximum performance, install DIMM memory modules in pairs of the same size.
— Install DIMM memory modules in the order shown below.
The following table describes the memory configurations supported by the HP Z210 Workstations.
Supported configurations
Four DIMM slots
●
Memory configuration from 1 GB to 32 GB
●
DIMM installation order
38 Chapter 7 Installing memory
http://www.hp.com/go/productbulletin
Z210 CMT
for specific DIMM compatibility
Z210 SFF
Supported configurations
Four DIMM slots
●
Memory configuration from 1 GB to 32 GB
●
DIMM installation order
ENWW